YAVAPAI COUNTY PLANNING AND ZONING ORDINANCE Page 39 RMM (Residential; Single Family; site built, factory built and Multi-Sectional Manufactured Homes, no single-wide manufactured homes) Permitted Uses: Where no Zoning/Density District has been combined, then all provisions of Density District 10 shall prevail. (See Section 516 (Density Districts), most common ones shown in attached chart.) A. All principal and accessory uses and structures permitted in the R1L Zoning District. B. Multi-Sectional Manufactured Homes, as defined under Section 301 (Definitions). To be permitted, Multi-Sectional Manufactured Homes must conform to all provisions set out in Section 301 (Definitions) and Section 552 (Manufactured Housing/Multi-Sectional Manufactured Housing Standards). C. Factory Built dwelling as defined under Section 301 (Definitions). D. Steel storage containers to meet the minimum requirements as provided under Section 564 (Outside Storage). E. Educational institutions (publicly funded) as defined in Section 301 (Definitions) (in any permitted buildings), except that a charter school may not operate in a single-family residence that is located on property of less than an acre. F. Religious Institutions (in any permitted buildings) upon Conditional Use Permit approval. Zoning/Density Regulations (in feet unless otherwise noted) Dist. Min Lot Size in Sq. Ft. per dwelling Min Lot Width and Depth Min Yard Setbacks Min Building Spacing is 3 Feet all classes Max Building Height Stories / feet Max Lot Coverage Percent Front Rear Interior Exterior 7.5 7,500 75 20 25 7 10 2 30 50 10 10,000 80 20 25 7 10 2 30 40 12 12,000 90 20 25 7 10 2 30 40 18 18,000 100 30 30 10 15 2 30 25 25 25,000 130 30 30 10 15 2 30 20 35 35,000 145 40 40 20 20 2 30 15 70 70,000 200 50 50 25 30 2 30 15 2A 87,120 225 50 50 25 30 2 30 10 175 175,000 300 50 50 30 50 2 30 10 5A 217,800 325 50 50 40 50 2 30 10 10A 435,600 500 50 50 50 50 2 30 5 36A 1,568,160 500 50 50 50 50 2 30 5 SECTION 411 RMM DISTRICT